This kit contains the Only the SmartSpark LS Module.
It is Preprogrammed with advance tables suitable for a wide range of normally aspirated high performance
Status LEDs show trigger inputs.
The unit is fully encapsulated construction without any internal voids and has heavy duty 12 pin Deutsch connectors used for signal connections.
It utilizes the same mounting pattern as competitive units, 6.0"L x 3.5"W x 0.63"H.
New installations require wire harness Part # 119002, 119003, 119005, or 119006 depending on mounting location.
If replacing MSD installations, use adapter harness Part # 119004.
Using the optioal USB Interface and PC Link software, you can digitally set launch, burnout, and maximum RPM limits with
100 RPM steps from 3,000 to 9,900 RPM.
The USB interface and PC Link software allows programming a
custom advance table based on RPM and manifold pressure.
New SmartSpark Log software displays real time engine data
during initial setup and dyno tuning.
Individual cylinder timing (ICT) capability with RPM based
offset up to 5 with 0.1 steps.
Three general purpose input terminals. Inputs can be used for RPM limits and multiple retard functions including driver adjustable retard (requires optional RTD-1 ).
The Mode switch allows selection of basic functions.