| Racer Net: ||$285.00/Each|
| Our Price: ||$260.95|
| You Save: ||$24.05/Each|| (8%)|
This extra capacity deep pan helps the TorqShift 5R110 transmission better handle the high stresses of towing and hauling. PML designed this new pan to accomodate the large internal filter that Ford introduced in 2008. It fits Ford Super Duty F250, F350, F450, F550, E350, and E450 with these engines:
- 2008 to 2010 trucks with 6.4 Power Stroke diesel with internal transmission oil filter
- 2008 and 2010 trucks with 6.8 V10 with internal transmission oil filter
Please check if you have a pan with the internal filter before ordering. For the 5R110 transmission, Ford added a new style of transmission pan and filter in 2008. The new style has a larger transmission pan and a filter that is internal, located inside the pan. 2008 and newer vehicles can have either the "new style" transmission pan with an internal filter or the "old style" pan with an external filter. Most F350 trucks seem to have the "new style" while most F250s have the "old style" pan.
External Filter Style Pan
Pictured below is the old style stock pan and external filter.
If you have an external spin-on transmission oil filter near the bell housing (as shown), PML pan, part number 9973, is for you.
The Ford logo is on the side.
Internal Filter Style Pan
Pictured below is the new style stock pan.
It is larger to accomodate an internal filter. If you have this larger pan with internal filter, this PML pan, part number 11049, is for you.
The Ford logo is in the middle.
2007 and older vehicles use our 9973 external filter 5R110 transmission pan.
Ford trucks with the 5.4 gas engine usually have the exhausted routed too close to the stock pan to allow for a larger transmission oil pan.
This pan has a boss on the driver's side which is a location for a temperature sensor.
PML designed this pan to work with the stock filter.
The pan has cast-in filter supports inside the pan (see image at left). The fluid level is at the same place with the PML pan as with the stock pan. The pick up for the transmission fluid is at the point with the PML pan as with the stock pan. A filter extension is not needed.
PML recommends a flexible rubber-cork gasket with this pan. These gaskets work well to seal machined surfaces, such as the gasket flange of the PML pan and the transmission housing.
Reusable thick rubber gaskets are intended for use with stamped steel stock pans. PML recommends against reusable rubber gaskets with our pans for several reasons. They nick easily, resulting in leaks. Their hole guides can cause gaps between the PML pan and the transmission case mating surface. Stamped steel stock pans flex and conform with the reusable rubber gaskets to provide a seal. PML sand cast aluminum pans have thick machined flanges and DO NOT flex.
PML Transmission Pan Features
- Increased oil capacity for cooler temperatures
- Sand-cast aluminum with raised fins
- 3/16-inch thick wall construction to add strength to the transmission case
- 3/8-inch thick gasket flange will not bend when bolts are tightened
- Machined gasket surface for a secure seal
- Boss cast into pan can be machined for a temperature sensor
- Magnetic drain plug for easier, less messy maintenance
- Mounting hardware provided
Gasket and filter not included (use stock parts).
Volume: 4 qts. over stock
Dimensions: Click here for dimensions.
Number of Bolts: 20